-
Posts
47 -
Joined
-
Last visited
Reputation
10 GoodAbout screaming red
- Birthday June 16
Personal Information
-
Name
jim vrantsis
location
-
Location
MISSISSAUGA, Canada
Converted
-
City
MISSISSAUGA
Converted
-
Home Country
Canada
Converted
-
Bike Year and Model
1999 yamaha royal star venture
-
Eck, You where dead on found wires that where just pulled apart just behind headlamp assembly. Thanks alot saved me a ton of fustration. screaming red
-
All my running lights are not working headlight front turnsignals and passing lamps rear brake light. My rear brake light works when being applied and my front signals work when using switch. Headlight totally inop. Checked both fuses ok. Is there a running light relay? Anyone with suggestions screaming red
-
Checked both fuses headlight and turn signal ok will check hi low switch. Turn signals do work only when you use the indicator switch. screaming red
-
Hi to all, I did some work on my forks and put it back together today all was working fine last night. Now i have no lights, headlight, turn signals and rear brake light. Now when i hit my turn signal they work fine and when I apply my front or rear brakes the brake light works. Headlight completely inop and no driving lights at all. Looked at harness no pinched wires at steering stop. Any help woud be welcomed. Screaming red
-
Has anyone seen a 12 inch short yamaha star windshield in any dealers around you? Everyone is out of stock including Yamaha. Screaming Red
-
Hi to all, I bought my bike with a new Michelin Commander on the rear and I got 25000 kms on it before I had to replace it. Just prior to replacing it the tire was noisy in turns and was cupping. I just bought E3's and put 500 kms on them and so far impressed with noise,, ride and easier to lean, so far so good. Screaming Red
-
Thanks for all your replies and sorry I should have put second gen in my posting. Its 10 degrees today in Ontario Canada and looks like great riding weather. Have a great day guys. Sreaming Red
- 11 replies
-
- appreciated
- arm
-
(and 3 more)
Tagged with:
-
Just wanted to make sure, I just remembered a bolt on that side. Screaming Red
- 11 replies
-
- appreciated
- arm
-
(and 3 more)
Tagged with:
-
Hi to all, Just had my rear tire replaced and something does not look right. I remember seeing a nut and lock ring on the right swing arm, can't be sure but not feeling safe riding. Any help would be appreciated. Screaming red
- 11 replies
-
- appreciated
- arm
-
(and 3 more)
Tagged with:
-
Thank guys for all your info, I did the self diagnostic check on the cruise including the throttle check all ok. SET light will turn off using clutch, SET and RES light goes off using front and rear brakes. The only thing I noticed the diagnostics said when performing throttle diag it will turn the throttle fully and then back it only turned maybe half befor turning back is this ok. Throttle cable is ok and adjusted correctly. Screaming Red
-
Hi all, I have the left lower fairing off and see the cruise control actuator, Should I tighten the cable or loosen it? Screaming Red
-
Thank you Bummer and thanks to all. I will check the actuator in the morning. I also noticed what looks like a vacuum hose by the rear brake pedal leading to nothing. Screaming Red
-
Thanks for your replies. I am seeing the vacuum actuator mentioned a few times, can you tell me where that is located? Screaming Red
-
I aleays thought the cruise control should not be deactivated by just putting your hand on the accel grip. I will open up the switch and look if anything is loose if all ok maybe I need a new one? Screaming Red
-
Hi to all, I have read some concerns about the cruise control but this is a bit different. When I set the cruise all is ok but when I rest my hand on the throttle the sightest twitch either way will disengage it. Is there a way to only have the cruise disengage using front or rear brakes. I like riding with both hands on my grips and tried adjusting throttle cable but still the same. Any help would be appreciated. Sreaming Red