While reading the thread about the starter clutch someone asked about a puller that would work. I found one from Dennis Stubblefield Sales, Inc. You can find him at www.dssalesusa.net . It is a special 12 hole disc flywheel puller. The model is MP#37. It comes with the 8mm x 1.25 bolts but I bought some a little longer to use. It is a round disc with holes arranged in it. You line up the 3 holes in the rotor with the puller, install the bolts through the puller and screw into the rotor. You screw the main bolt through the puller into the hole in the rotor till it touches the flywheel. I didn't put anything in between to protect the hole in the end of the crank as the bolt didn't seem like it would damage the hole. When you screw it in it will pull the rotor out. It was so easy I was surprised after reading about all the problems people have had getting the rotor off. I hope this will help someone. Sam