Junior

Thanks for the reply. I have a 2007 RSV that I just changed the slave cylinder and while I was doing that I noticed oil leaking from the shaft seal. I've read other people's comments about this job and they mentioned to check this out before closing cover up. Well I ordered a seal and I was hoping someone had replaced this easier than what the manual said. Thanks again for your comments.

Have a leak at the seal area on the shift shift. Anyone ever change this out

Very nice 👍

Was wanting to know if anyone here has installed this system on a RSV ? I'm looking for maybe a picture of it installed on a RSV . Mine is 2000 mm model. I've been looking at there website and installation manual and it seems to be something I could install.

I bought a Corbin backrest that has somewhat of side support.. Never did hear back from Mr Dawson

I ended up getting a receiver to bolt where ball is and aluminum cargo basket for hauling stuff. Then I got one of the small custom chrome cargo racks utilizing the ball mount area.

I have the 2000 mm edition and I had to add lowering kit, front tire change,and risers to get handlebars back. I can flat foot it now. Still very heavy to support. I am 5'7" and older range. These bikes are usually affordable because of there weight and height off the ground seated, and tend to be top heavy . I haven't rode it much because of this. Things to consider before buying.

Looking for a cargo rack to go onto back of my 2007 royal star venture. I have a voyager kit installed with a 1 7/8 " ball on it. Don't want to get a trailer.

Installed a voyager kit on 2007 RSV. Anyone installed any sort of protection or guard on front of fenders? They are fiberglass.

Has anyone installed fender guards/ protection on front of fenders on the Voyager kit. I have the fiberglass fenders.

Good luck

Led. Is this the one that requires less power to operate ? And thanks for the quick response.

Where did you find this one ?

Yeah it's 14 degrees this morning with 8 inches of snow from Monday. New Tazewell Tennessee area. Not liking it.

Is there instructions with this ?

Thanks to you both for helping me out.

Cannot locate one on that site that fits the bike. Possible generic?

Thanks for letting me know. I will look for them right now.

Thanks for your response. I read about show chrome used to make a version.

Looking for passing lamp assembly or similar designs for 2000 RSV mm edition.

Good luck, I'll be praying for you also.

Well I took the gas tank off , removed throttle cables and dropped handlebars down and over to the right. I talked with Ed Williams and he said the stock cables will work. I rerouted cables at triple tree and put it back together. Had to adjust cable slack at carburetor and at handlebar throttle point. Took several tries there to get good snap back on grip. It was a challenge to put the cables back in attachment point where the cruise control cable meets. Thanks for everyone's support and information.

Do you have any ideas on where to look for these, what years would fit. Thanks for your response.

Are you still out of service ?

Could not pull enough slack to make a difference. Will have to remove tank and other things in my way.