Junior

Yeah it's 14 degrees this morning with 8 inches of snow from Monday. New Tazewell Tennessee area. Not liking it.

Is there instructions with this ?

Thanks to you both for helping me out.

Cannot locate one on that site that fits the bike. Possible generic?

Thanks for letting me know. I will look for them right now.

Thanks for your response. I read about show chrome used to make a version.

Looking for passing lamp assembly or similar designs for 2000 RSV mm edition.

Good luck, I'll be praying for you also.

Well I took the gas tank off , removed throttle cables and dropped handlebars down and over to the right. I talked with Ed Williams and he said the stock cables will work. I rerouted cables at triple tree and put it back together. Had to adjust cable slack at carburetor and at handlebar throttle point. Took several tries there to get good snap back on grip. It was a challenge to put the cables back in attachment point where the cruise control cable meets. Thanks for everyone's support and information.

Do you have any ideas on where to look for these, what years would fit. Thanks for your response.

Are you still out of service ?

Is there a size listed? Like chest or sleeve length you could give me ?

Could not pull enough slack to make a difference. Will have to remove tank and other things in my way.

I will look at it tomorrow and let you know how it turns out. Thanks for your quick response.

I'm about 5'7" and 180 lbs. I'm wondering about fit?

I cut up rubber pinch block and inserted under existing rubber inserts and used gorilla glue to secure. I think it will work fine. The only thing is when handlebars are turned right, the throttle grip is not turning freely. Center and left turn is normal. Any one else have this problem after installing Baron's risers?

Looks good I will try to follow through with your example. Thanks for your response. I have noticed throttle binds when turned to the right. Any ideas?

Thanks, I did that but they don't touch the triple tree anymore. 1 1/2 " away. I guess I'll look for filler pieces of rubber blocks.

I just installed the Baron's risers on 2000 RSV. Seems to feel better, but haven't rode it yet. What do people do to replace the rubber inserts located between fairing and handlebars? Mine do not fit anymore.

Haven't heard from about my request for armrests.

Thanks for your response, I ordered a set of barons risers. I will follow up with how it helped.

Thanks for giving me your info. 2000 royal star venture is what I was thinking about using these on.

Would like some pro and cons of adding risers.

Well I think 10 1/2'' ' from top of grab bar is about right for her. I would like to purchase a set from you when you are available.

I'll get back to you when I can get measurement.