spike13

one plug on bottom one filter on rear of motor and sight glass on right side down low fill to middle of glass checked with bike upright and level

LED's

http://www.venturerider.org/classifieds/showproduct.php?product=3738&title=butt-butler-seat-mod&cat=25

i installed ivans kit myself during a valve adjustment. went in easy and made a big difference in throttle response. i run l.a. choppers mufflers and had some after-fire before jetting and that is gone. i will say i noticed a slight drop in fuel economy but that may be my own fault i have a problem twisting the throttle too much. i would do it again given the chance.

i had a set of these they put some light right in front of the bike but the two i had didn't last even one summer i replaced them with the sunspots from custom dynamics which do put more light on the road and so far are still working

i love the look of the vision but when i opened the saddlebags i laughed cause they were smaller than my back pockets. i do want to get a better look at the cct and am thinking i may demo ride a twin cooled ultra

Paul Gunn did this conversion and did do a write up with pics on a venture page on facebook you could pm him

i think what i would do is try to match the alignment of the tabs and friction pads on the new parts with the old ones and then install

tint helps with road glare

i may be able to help you out what you thinking about?

i put a hagon standard shock on last fall much nicer ride than stock

if you cannot find a loaner kit check with your local shops i found one here that will do an even up exchange for needed sizes

service manual http://labs.trunkful.com/vrmanuals/index.cfm

slick

if you are smelling raw fuel i dont think it's a carb problem i would check the air filters and plugs could just be time for a tune-up. i got caught in the rain once on an old honda and she started running bad turned out it was a cracked coil letting rain in water and electricity do not mix well good luck finding your problem hope it's easy enough:080402gudl_prv:

as long as they are full synthetic shouldn't really matter all will be great for your motor do however watch the first couple changes for early filth synthetic does a great job cleaning the inside of your motor

may not open a beer can but should be able to weld it shut:stickinouttounge:

early X-mas gift [ATTACH]81081[/ATTACH]

three years and a whole lot of:mo money::mo money:

:rotf::rotf::rotf::rotf:

Jeff I just put a Hagon standard on mine a few weeks ago and love it only bad part is adjusting preload had to remove the shock. Is a big price difference compared to Works.

is it a dirty left rear carb? if so it is not leaking is more than likely oil coming from airbox dont worry about it just watch oil level when filling

the coupon worked online with the sale price but they want $90 to ship it i asked in the store a while back if i could use coupon when on sale they said yes but unsure if store is offering same price

anyone know if harbor freight will match their online prices in store? the tag along is on sale for 329 with the 25% coupon i should be able to get one for 250 but dont wanna spend another bill on shipping

http://www.utpr.com/rsrsvinstallation.html this is how a utopia mounts only using two bolts not sure on spacing of holes hope this helps a bit