Stator/Rectofier test

[sleepy2]

Finally found connector for Stator and I think I did it right except haven't tried test with bike running as I have to wait until Phantom can run throttle for me! Followed @Freebirds updated file on this took me a while to find the right plug to disconnect to do test. Checked for Stator coil resistance  1-2, 1-3, 2-3 and it showed .3ohms(used the 200ohm setting on lower right) 

Did next test on higher Ohms setting(kept it on 200 as instructions said ^100. Touched pins from pins to ground and reading was .5

To do AC test I put meter on 200~(upper left on dial with AC button pushed down(by Mastercraft) and touched 1-2,1-3,and 2-3  meter said around 23,24

Then last test was highest Ohms setting 20M and test showed 0.00,pins to ground.

Did I do the test right with my meter or should I try and get some help????

[Marcarl]

You could call.

[sleepy2]

Just saw your reply! I will tomorrow! Things have been off lately so haven't had a chance.

[sleepy2]

Just ordered a new Ricks Motorsports Stator, Kimpex HD Voltage Regulator and a gasket for Stator. Nobody has a Cover2 gasket for the chrome cover behind Stator cover(Cover1) from    Fort Nine  in Montreal Quebec Canada  $433can free shipping! Should arrive by Friday or Saturday!

[RDawson]

1 hour ago, sleepy2 said:

Just ordered a new Ricks Motorsports Stator, Kimpex HD Voltage Regulator and a gasket for Stator. Nobody has a Cover2 gasket for the chrome cover behind Stator cover(Cover1) from    Fort Nine  in Montreal Quebec Canada  $433can free shipping! Should arrive by Friday or Saturday!

Partzilla shows to have the gasket in stock. I think I have one if you don’t find it. 

[sleepy2]

@RDawsonThanks for the information and offer, have a couple more dealers to try yet! Probably just use some gasket material I have leftover from gasket I made for clutch cover last fall to save time!