Stator/Rectofier test

[sleepy2]

Finally found connector for Stator and I think I did it right except haven't tried test with bike running as I have to wait until Phantom can run throttle for me! Followed @Freebirds updated file on this took me a while to find the right plug to disconnect to do test. Checked for Stator coil resistance  1-2, 1-3, 2-3 and it showed .3ohms(used the 200ohm setting on lower right) 

Did next test on higher Ohms setting(kept it on 200 as instructions said ^100. Touched pins from pins to ground and reading was .5

To do AC test I put meter on 200~(upper left on dial with AC button pushed down(by Mastercraft) and touched 1-2,1-3,and 2-3  meter said around 23,24

Then last test was highest Ohms setting 20M and test showed 0.00,pins to ground.

Did I do the test right with my meter or should I try and get some help????