emtdouggood Posted April 7, 2010 Share #1 Posted April 7, 2010 Is the top and bottom bearings the same on the fork head on a 83. Had to cut the bottom bearing off. This must of been my problem with the steering not going striaght.Also sould there be a seal on the bottom. Had someone come over to trade bikes. He basicly told me my bike was not worth anything.he had a 99 suzuki 500 and wanted me to give him 1500 plus my venture. thanks Doug Link to comment Share on other sites More sharing options...
Sheradan Posted April 7, 2010 Share #2 Posted April 7, 2010 The bottom bearing is press fit. It should be pressed on and off. No seal, just large cupped washer looking thing. Link to comment Share on other sites More sharing options...
Squeeze Posted April 7, 2010 Share #3 Posted April 7, 2010 Is the top and bottom bearings the same on the fork head on a 83. Had to cut the bottom bearing off. This must of been my problem with the steering not going striaght.Also sould there be a seal on the bottom. .. Yes, these are different, Industrial Numbers are 32005 X/Q and 32006 X/Q. Yes, there needs to be a Seal on the lower Bearing to keep the Road Grim out and the Grease nice and working. .... Had someone come over to trade bikes. He basicly told me my bike was not worth anything.he had a 99 suzuki 500 and wanted me to give him 1500 plus my venture. thanks Doug Just play nice and show him where the Carpenter left the Hole in the Wall ... :whistling: A 500 Suzuki ? What the H3ll is that ? A Starter Motor ? Link to comment Share on other sites More sharing options...
emtdouggood Posted April 7, 2010 Author Share #4 Posted April 7, 2010 I looked where i get most of my bearings and none listed.(McMaster-Carr)Any other place to get these at a good price. Link to comment Share on other sites More sharing options...
capn eddie Posted April 7, 2010 Share #5 Posted April 7, 2010 I looked where i get most of my bearings and none listed.(McMaster-Carr)Any other place to get these at a good price. Go to goallballs.com that is where i bought mine , stearing head bearing kit comes with both seals and bearings for $33.54 Link to comment Share on other sites More sharing options...
GigaWhiskey Posted April 7, 2010 Share #6 Posted April 7, 2010 Did allballs for momma's 750. Went from the loose ball bearings to the allballs tapered bearings. Nice! It is a very common mod on the old 750's. I have not heard or read a complaint other than the instructions might not be as descriptive as you would like. I dunno what the kit for the VR's include but mommas came with 2 washers of different thinkness. You had to measure and then guess which one to use. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now