Search the Community
Showing results for tags 'teflon'.
Found 3 results
-
I want to shim the carb neeldes on my 2006 venture. Question is, when you add a shim to the needle, does it go under the c-clip on top of the teflon ring or do you slide it up the needle under the teflon piece? Thanks,
-
I just installed the gauges this past week, it took me 3 nights to complete I get home around midnight and would work on it for a couple hrs each night.. Turn out great I did have a small leak at the temp. probe I took very lightly coat of teflon and coated the threads, was careful not to get any on the end of the fitting. Not real crazy about teflon tape, that is from my personal experience.. Monty show me a trick on mounting the gauges and it remove the room for error on the alignment, take a vise grip and clamp it in place drill and screw in place no need to remove and allow for errors.. Also the dremel tool I think was the best for cutting easy to guide and less room for a real problem They are one the neatest gadgets going...
-
Hey everybody, I just removed my rear wheel to lube/inspect my new-to-me 86 Venture. I found the bushings on the suspension links completely dry and corroded. I also found the plastic inter- bushings worn out. Has anyone used anything other than the teflon bushings to re-bush the links? I can still order the teflon ones from Bike Bandit but they are $24 each {6 required}... Thanks for any help! ps I am sure these have never been lubed..... things we should check on old bikes...
