Hi All,
Just wanted to get aquainted with everyone so that as I go through my project and ask for help you'll know what I'm up to. A couple er 3 years ago I started a project to put a Venture drive train and electronics into a legend's race car. Not just a standard legend but one that would have two seats and be registered for the road. Fast forward to now,,,,,,The frame has been widened and is complete, the body has been widened and is mostly complete except for the hood and grille. The rearend is installed with a 4link. The engine/trans is mounted but not yet connected to the drive shaft. The current project is the exhaust. We intend to run them into side pipes. The two biggest projects left is an offset drive between the trans and the drive shaft to reverse the direction of rotation and to get the output back to the center of the vehicle to line up with the drive shaft and of course the electrical system. I intend to incorperate the complete electrical system from the bike into the car including the dash board/speedometer, stereo, CB etc. At the moment I don't have any pictures handy but I'll try and get some posted later. Thanks in advance for allowing me to lean on your knowledge as I'm sure I will as I attempt to get this project going.
TR