Jump to content

Recommended Posts

Went to change the lube in the rear end and started with the wrong part. I twisted off the cap on top of the rear end thinking it was the filler. It wasn't. What is it? How much damage have I done?

Link to comment
Share on other sites

Went to change the lube in the rear end and started with the wrong part. I twisted off the cap on top of the rear end thinking it was the filler. It wasn't. What is it? How much damage have I done?

 

That would be a vent cap? Does it fit back on tightly? I would think, if it fit back snuggly, that you wouldn't have done any damage.

Link to comment
Share on other sites

Have you got a picture? If I'm thinking right you only broke off the cover that covers the filler plug, not a biggie. The drain is at the bottom and the filler plug is half ways up at the rear of the pumpkin. The plug needs an allan wrench to take it out, and the cover prys off,,,,,but a picture would help.

Link to comment
Share on other sites

It's not the filler plug thing. I found it after I messed this piece up. Then I changed the lube. I think this was the original fluid (33,000) because it was black as tar and the magnet was covered with so much goo I could not figure out what I had until I wiped it off!! I will change it again with the next 2 oil changes to clean things out. Anyway, I think it must be some kind of dust cover but it does not go back on tight now because I twisted it. Underneath it is a cone shaped item that looks like it has a vent hole in it. Can I just cover this with a rubber boot of some type or electrical tape? What does anybody suggest?

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...