Search the Community
Showing results for tags 'procedures'.
Found 4 results
-
Need some proper info on tightening the steering nut such as torque specs, procedures, etc. I installed new races and bearings top and bottom. Im attempting to install the tree and, following the shop manuals tightening procedures, it just seems to be a bit off. It calls for tightening the nuts to 37 ft lbs but when I tried that it tightened up well before it even would have clicked, which it didnt. The whole tree was way too stiff and hard to turn. Now, just to clear stuff up: the races are fully seated, bearings are fully greased with Honda Moly 60 and im using the machined spacer that SkyDoc sold a while ago to replace the rubber "washer". So, any suggestions? -
I rec'd not 1 but 2 carbtune kits for Christmas. I finally got around to downloading the step by step procedures and did follow the easy steps. All I can say is WOW, what a difference. I've put on almost 100 miles and I can't believe the preformance and I don't get any popping. Thanks to this forum and I can't remember who posted the pics and procedures, but it was sure worth the whole 45 minutes it took me to syce the carbs. Bob
-
Any procedures for replacing these?
-
can anyone give me the best way to remove the rear wheel? I have seen lots of different procedures which vary quite significantly thanks Pete:confused24:
