Search the Community
Showing results for tags 'equalizers'.
Found 3 results
-
Hi guys, hoping one of you savvy lads out there can help me out. I have installed some bright LED signal lights on the RSV, and being LED they will naturally blink rather fast.. To slow such lights, we typically install Load Equalizers.. No problem there.. The recommended ones from Custom Dynamics: Genesis Metric Load Equalizer 7.5 Ohm GEN-7.5-30 These are small blocks that have two purple and one black wires coming out of them.. And ideally you install one on each end of the bike for each set.. one of the purples to the GREEN and BROWN signal light wires and the black to ground.. Simple right? ergh I wish. I've temp installed one at the front under the fairing where the wires are very accessible, and the other in the bundle under the license plate.. Brown and green.. Though they will slow down the 4 way flashers.. they have NO effect on the signal lights.. I know I have the right wires because when I pull them apart the signals lights stop flashing... I then took the large bundle under the seat, to the left side, and plugged one of the equalizers into the green and brown wires there.. and now the 4 ways and signal lights flash fast.. I have the SAME load equalizers working on my VSTar, it works.. the SAME one won't work on the RSV.. I have 5 of these, and none of them work on the RSV but they will on the VStar.. Am I doing something wrong here as to what and where I'm plugging these in? I've seen other posts where people have the same same equalizers working on their bikes and mine won't work.. Any ideas, suggestions, advice? Am I plugging these in the wrong wires? Fast flashers don't bother me but you know how it is.. how many times before I growl at someone for them saying "Hey Mister, you know ya got a light out??" Thanks in advance for your assistance.. If you're using something else that works, let me know what it is and WHERE / HOW you plugged it in, please.. Cheers =) Bike is almost ready for the road.. that is when the ice melts.. -
I've swapped out my signal lights to some decently insanely bright LEDs and have a pair of Load Equalizers to take up the load to make the signal lights flash at the normal rate etc etc.. One for the front and one for the rear lights.. However, though I know which wires go where, I do not know the best location to tap into the wires for this.. Can someone who has done this before be able to point out to me where best to located the wires on the bike to tap into for the best (note easiest) access? Thanks in advance. Cheers
-
Hey guys. A few years ago I switched to LEDs to save some power and changed the flasher relays so I could get some power freed up. Well over the winter I upgraded the stator so the power problems are gone. With that I now find that I want my automatic canceler back working so Im gonna put the original relays back in the bike. I now need to install load equalizers. Problem is where should I put them? Do I need 2, one for the front and one for the back and which one should I get? Help me out here so I can get rid of my grandpa flasher syndrome!!! LOL
