COSuperfly
-
Posts
8 -
Joined
-
Last visited
-
A MIRACLE !!!! So I tried everything all have posted and nothing. I studied the wiring diagrams until I went dizzy. I was standing by the bike scratching my head and wondering what to do next and at the same time, squeezing the clutch lever over and over in my frustration. I trurned the ignition switch to ON and low and behold, the lights and radio came on and was able to crank the engine!!!! Whats up with that???
-
The latest testing: Connectors apper to be fine. Headlight or tail lights do not come on with switch to ON. With switch ON, headlight fuse reads .60 volts. Main fairing ground secure to side of bracket and to frame. Negative battery post and frame: With ACC - 9.7 With ON - .34 So it appears I have a grounding issue?
-
Audio fuse is good and new.
-
The backup fuse is good. I even replaced it with a new one. The radio is not on and will not turn on with the switch to ACC or ON. No orange lights. I performed the tests exactly as you instructed and the voltage readings are correct. Still no lights, no fuel pump noise no nothing when the switch is either in ACC or ON position. Anthing else it might be or is it time to take it to a dealer?
-
Goose - The battery is at 12.8 volts. Outcome of testing: Test 1 = 12.8 Test 2 = 12.5 Test 3 = 12.5 Test 4.1 = 12.5 Test 4.2 = 12.3 Test 4.3 = 12.3 at left side of fuse connection Next?
-
Thank y'all for all the help. I know just enough about electrical circuits to get me in trouble. I get alittle overwhelmed by all the wires. The ground is secure to the motor mount and tested out. There is power going to the switch. I guess the next step is see if power is going out of the switch. It should be since its new and the previous one was working. From the switch, then where? Thanks a bunch!! Sparky
-
I'vr already replaced the switch. "Replaced the ignition main switch with a new one because it was showing signs wear."
-
2001 RSV with 55k miles. Went to start my bike and didn't wait for the 'clicking' fuel pump? to stop before I pressed the starter button. I quickly let off of the starter switch - the bike didn't have enough time to start but did briefly crank. I then set the ignition switch to off, then on, and no power at all; no fuel pump noise, no lights, no radio, nothing. Same thing after numerous attempts. What I have done: All fuses including the main checked and ok. Even replaced some including main. Battery terminals clean and wires secure. Battery checked and voltage is fine. Wires clean and secure to the starter relay. Replaced the ignition main switch with a new one because it was showing signs wear. Still no power when the ignition switch is set to on or acc. What else should I check?