Well, initially going through and searching out how to remove the gas tank to get to the radiator cap (these forums are pretty thorough when you search it out on 'bing' but not so when your actually in search on this site) I found photos on how to do such. With the replacement of the original radiator back onto the bike (that lower hose clamp is a pain to get back on and tightened!) and the tank removed, I found a couple of possible issues- at least they may be issues... Refilling the radiator (after taking photos of the potential issues, I found what looks like oil coming out of a plastic piece with what looks to be a foam filter of some sort sandwiched in between- only on the left side of the bike as you sit on it). I cleaned up what I could, replaced the tank, and started her up. She ran well, waited till the fan kicked on and then shut her down for a bit while I went in to change for a Little ride to see how she ran. All is well thus far with a one gallon pail under her while she cools. If there is more antifreeze, then I didn't do well enough. I did as suggested by other members and looked over the plugs under the fake cooling fins, no issues there.
So, here comes the questions regarding the following (I hope) photos... As I was removing the fuel line from the fuel cock, I couldn't get the fuel line off without a little bit of tugging, and thus doing so, I pulled out the metal brass tube inside the fuel cock... Quickly realizing this may be an issue, I took a photo for later reference and replaced it, pushing it back into place, while removing the fuel line from the lever. Second issue was as described above with the oil...
Any suggestions would be welcome. Sorry folks, tried to upload the photos and can't.