Lobo Hurfiano Posted September 14, 2008 Share #1 Posted September 14, 2008 Dash display-dead rear unit-dead Not that I'm totaly inept or anything,(once tried to replace a faucit washer and wound up replumbing the entire house). So, where to start?? I've located a CLASS fuse on the print-where is it located on the bike? (86VR) and is it a standerd auto part? Any thing I should be aware of? PLEASE,please --don't say pins-circuit board. Orphand Wolf Link to comment Share on other sites More sharing options...
GeorgeS Posted September 14, 2008 Share #2 Posted September 14, 2008 Start by inspecting the Electrical connectors about 6 inches from the control head. Lightly tug on the wires on both sides of the plugs. The crimps are known to come loose. Also, clean the pins inside of the plugs. If that does not work, open up the control head, and do some resoldering where the wires connect to the circuit board. The fuse, is in a seperate holder, has plug going to it, Two, Red/Blue wires into and out of the Plug. The fuse holder has Red/Blue wires into and out of it, also. Link to comment Share on other sites More sharing options...
Lobo Hurfiano Posted September 14, 2008 Author Share #3 Posted September 14, 2008 Thanhs George--------Stand back-I'm going in Link to comment Share on other sites More sharing options...
Lobo Hurfiano Posted September 14, 2008 Author Share #4 Posted September 14, 2008 I've got to stop being tramatised by that faucit washer thing,but things just just fall apart if I look at them wrong. Plug had fallen out of the controler.---feel so stupid. Thanks for the back up. lobo h Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now