2step
-
Posts
4 -
Joined
-
Last visited
-
Rode about 20 miles today, everything seems fine Thanks 2step
-
OK, thanks everyone for the help, i did everything on here and everything seems very quite just spinning the wheel, I will test drive tomorrow. My guess it was the hub fingers, they were all rusted, I cleaned them up, greased with Moly 60 and used a dremel with wire brush attachment to get down in the holes and clean them. Again thanks. 2step:guitarist 2:
-
Thanks everyone for the info, I will try all of them till I find it. Again Thanks. I will let you know when I figure it out.
-
OK, got this noise from the rear like a wheel bearing going down, so I put her on a lift, spin the tire and its got a spot, same place every turn, like a flat spot on bearing. So I pull the axle, then spin the tire and quite as a mouse, so I take the wheel in to the shop and have both side wheel bearing and seals replaced. Came back home put it all back together, SAME THING, with axle in and while riding same noise, axle out no noise. Any help would be greatly appreciated. Thanks 2step