resoldered class connections.. now what?

[silversurfer]

so now theres no more error message on class. My class only works to the rear suspension and only when key is on accessory. when you press the rear button the compressor kicks on and the rear end seems to pump up but when you push the front button there is absolutly no change on the screen. sooo what gives? I have the manual and i see theres a cuple of things i can look at in the system but hey if sumone canm kina pin point it i would greatly appreciate it.

[dingy]

The CLASS system is designed to only work with the key in the ACCY position.

 

This is probably to keep riders from adjusting it while riding, and being distracted.

 

With total disregard for the previous sentence, the link below details how to power up CLASS system when key is in RUN position.

 

As far as front end not working, I would suspect a dirty push button might be a possibility in the controller head.

 

http://www.venturerider.org/forum/showthread.php?t=51582

 

Gary

Edited February 25, 2011 by dingy
ctrl V is very hard to remember

[bkuhr]

The CLASS system is designed to only work with the key in the ACCY position.

 

This is probably to keep riders from adjusting it while riding, and being distracted.

 

With total disregard for the previous sentence, the link below details how to power up CLASS system when key is in RUN position.

 

As far as front end not working, I would suspect a dirty push button might be a possibility in the controller head.

 

Gary

the "link below" must be the same place as the ebay link:witch_brew:

[dingy]

Gettin old is hell.

 

I even went back & edited post after yours and it was still in memory buffer, all I had to do was paste it in.

 

Gary