Bluesman Posted April 3, 2009 Share #1 Posted April 3, 2009 I'm in the middle of installing my factory passing lamp mount and ran into a snag. I've just attached the passing lamps themselves to the mount and now I'm in the process of attaching the turn signals, problem is, I can't make the connection because of the rubber sleeve. Is this supposed to be removed before installation? Or is there a way to wrestle it on properly? (took a lot of twisting and pulling to remove the signals from the original bar in the first place) Bluez Link to comment Share on other sites More sharing options...
T.J. Posted April 3, 2009 Share #2 Posted April 3, 2009 WD-40 makes it a little easier to work with, to side in and out. Good luck. Link to comment Share on other sites More sharing options...
dragerman Posted April 3, 2009 Share #3 Posted April 3, 2009 I’m not sure how it works for the front but when I installed the run/break conversion kit into the rear turn lights I ran in a similar problem. I had a hard time to get the bulb socket with the rubber sleeve back into place. After applying a thin film of dielectric grease to both sides I was able to work it in... perhaps that might help Link to comment Share on other sites More sharing options...
Carbon_One Posted April 3, 2009 Share #4 Posted April 3, 2009 Silcone sprayed on the rubber helps as well. Larry Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now