Jump to content

priority9

Expired Membership
  • Posts

    3
  • Joined

  • Last visited

Reputation

10 Good

Personal Information

  • Name
    Brisket

location

  • Location
    Dallas, TX, United States

Converted

  • City
    Dallas

Converted

  • State/Province
    TX

Converted

  • Home Country
    United States

Converted

  • Bike Year and Model
    1996 royal star
  1. I have a 1996 Royal Star and I'm experiencing problems on startup. 1.I turn the key and hit the start button...It fires(runs for a few seconds) up then dies. 2.Hit the start button again....It just turns but doesn't start. 3. Turn the key to off position 4. Hit the start button...It fires(runs for a few seconds) up then dies. The error light (check engine light) flashes 9 times. I looked in the service manual and I can see nothing on 9 flashes. Has anyone experienced this before. Hard to diagnose If I don't know what 9 flashes mean. Not 8 flashes but "9". I have experienced the 8 flashes already during this bike restoration. smh. Thanks
  2. Greetings All My winter/spring project. 1996 Royals Star Tour Classic I inherited this 1996 royal star classic. I am excited to see this beast on the road. The poor thing was neglected for many years just sitting with gas still in it. Eventually turning into to dust and gunk. 1. Carbs rebuilt. (Tried it myself ended up taking it to someone to finalize my work) 2. Tank cleaned 3. Fuel lines and filters replace. 3. Battery and everything in between. I finally fired her up about a month ago (with my fingers crossed) and she ran. After about 20mins of riding around the neighborhod...it cut off I have narrowed the problem down to kickstand switch(should be arriving tomorrow) or ignition switch. It seems that ignition switch has plagued many, so I dove into this write up on the switch bypass. I do have questions to make sure I am correct and before I start blowing fuses. 1. Cut the Brown/Blue from the under side of the fuse box. (Leave enough room to play with) At the fuse box under side of the fuse box 2. Brown/Blue (Labeled "BR/L" in the circuit diagram) fuse box bus is connected to a RED 10AWG wire. The other end of the RED 10AWG goes to relay output. Is this the Started Relay? Ignition Switch Brown/Blue ("BR/L") 3. The yellow "Wayne" wire connects to the cut Brown/Blue. The other end of the "Wayne" wire goes in the activating coil. By activating coil, do you mean starter relay? Wow, I actually posted something on needing assistance.
×
×
  • Create New...