ken5124

Thanks, MY re solder seems to have worked.. Now to redo the front steering head bearings and put all of it back together !

Hey everyone, does anyone have a working CLASS controller for an 86 venture royale they would be willing to sell. ? I have the E1 error, attempts to check solder joints produced no change/ still only get the error message. Thanks Ken

Which wire on the class system wiring harness feeds power to it ? Thanks Ken

Thanks !

Thanks.. tried removing the air box this afternoon and I for sure can remove the cables from the OEM box/ !! Nice. May just leave the original in there . Ken

Hi guys, sorry the manual I have is hard to read, what do I all have to do to get the stock ignition box out ? As in where is it located and what has to come out to get to it ? Thanks Ken

I have the battery resistor in place and it works.. I will be jumpering the cmu and that should get rid of that warning. Will change the plug sockets around so the high beam indicator will be correct. Ken

So is there no way to get the cmu to stop displaying warning light >? BTw the yellow line has power.. still confused

from what i can see on schematics.. power feeds the system thru the blue with black stripe. this feeds the low beam green with red stripe, and the hi low light switch thru the blue with white stripe.. When the light switch is switched to high beams, power goes out to the highs on the yellow with green stripe, and if hooked together feeds the high beam indicator thru the blue with red stripe. the high beam indicator ground line is the light green line, so that is hooked to the black ground line. The lights out indicator or white warning light seems to be fed 12 volts by a red with yellow stripe.. which is eventually hooked into the blue with black stripe wire. that bulb also has the yellow line, which would appear to be a ground line? so when I look at the wiring in this post.. why do I get the white light going on with the CMU warn ing red light?? Thoughts ?? Ken

If you could that would be great thanks . Still confused about why the warning light is now coming on. Ken

Thanks, I have sen 2 different bypass wiring setups , so I guess I will try the other one.. Mine is an 86 BTW.

So i just did this bypass as indicated earlier.. I too have the white light come on with high beam and red warning light is now on.Is there a fix for this? I prefer not to have the red warning light on all the time.. and I would prefer the blue light on for high beams.. Suggestions.?

New starter arrived today.. Took Some pictures.. to confirm this IS a 4 brush starter Part number SMU0366 Got it from the link listed at the beginning of the thread. Now to wait for winter to be over. HAHA.

Thanks.. Plan to order it and will dismantle enough to verify it is a 4 brush.

Hi, Looking to confirm that the following starter will work on my 86 Venture. https://www.ebay.com/itm/-/132219977857? Thanks Ken