Jump to content

mega2500

Expired Membership
  • Posts

    31
  • Joined

  • Last visited

Posts posted by mega2500

  1. I removed the plastic shim and just built back with the correct shims -25thousands

    and gained 10mpg with sidecar on . got shims at local hardware store .05 each

    running today at 85deg it was about 1/2 to 3/4 on guage at 65mi per hr [35mpg]

  2. I was going to sell these for 29.95 $ U S but i see some of you need info now so I will let the cat out of the bag.

     

    To reinstall splines into yoke I take out inspection plug in top of shaft tube

    get two [2] 14" tie straps and slip them together at one end so you have a loop

    slip the loop in the inspection hole pushing it toward the back of the tube

    now with a long screwdriver or rod lift up on the yoke and pull up on the two free ends of the tie straps to cradle the yoke

    insert shaft into tube and into yoke add nuts and pull on one end of tiestraps to remove from the inspection hole isntall plug and you are done

     

    NC

    No charge

  3. Just rebuilt a set of 1989 carbs that had all 4 carb vents tied together then to a smog controll and then to a tee that tied the tank vent and the canister together

     

    after all was reinstalled the bike would load up when sitting {not running} so I removed the line from the tee to the canister and extended that line off the tee below the bike to vent as all other ventures do and no more flooding when first engine is shut down

    still good after 1000mi so I do not think you will hurt anything but someones feelings with the Cal EPA {I could vent on this also}

×
×
  • Create New...