Jump to content

kapebretoner

Expired Membership
  • Posts

    27
  • Joined

  • Last visited

Reputation

17 Good

About kapebretoner

  • Birthday 08/15/1959

Personal Information

  • Name
    Reggie McNeil

location

  • Location
    Sydney Forks, NS, Canada

Converted

  • City
    Sydney Forks

Converted

  • State/Province
    NS

Converted

  • Home Country
    Canada

Converted

  • Bike Year and Model
    1989 venture royale

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. well, i am doing something wrong, cause I can't adjust the headlight at all. is it possible that there is something wrong inside the headlight assembly.
  2. i have turned the adjusting knob about 100 times. After playing with it for over an hour, I decided to adjust my headlight manually
  3. I cannot adjust my headlight vertically. I have tried turning the adjustment knob, but has no effect. Is there another way to adjust the headlight.
  4. is there a brake reservoir for the rear brakes. if so, where is it located?
  5. I broke my plunger case and anti dive unit on my left fork. Bought a used one. i installed it and while I was at it I installed new seals, bushings plus new fork oil. Out and about on my bike and i notice that my forks are starting to bottom out. I adjusted the anti dive switch on the left side of the bike up to number 3 setting. I but 14 psi in the front and 21 psi in the rear. Front does not hold pressure.. I have oil leaks. i put in 400 ml of fork oil. I only did one side because it cost $130 to do one side. Any ideas or suggestions.
  6. got a used anti dive unit. I going to try and install it tomorrow. Is there anyway that I can refill the fork oil with the fork on the bike or does it have to be removed.
  7. i am going to order new seal, dust seal and both bushings and take the fork completely out of the bike this time.
  8. yes, yamaha seals. I did not replace bushings as they were on back order. I am going to try his controller in my bike and vice versa.
  9. replaced left front fork seal. all seemed good. fixed class controller re soldered joints. tested class system up to 14psi in front and rear. tried to decrease the pressure on the front and it would only derease to 7psi. once i added air to front fork the new seal started leaking. any advice would be appreciated. put 370 ml of fork oil in.
  10. has anyone had to bend their side kick stand. Bike will tip over quite easy while on the side stand
  11. Where can i buy a fork seal kit for my 89 bike.
  12. can't post pics as bike is parked at a friends. will be a couple of days before i am mobile again. I will check out ebay and Sky_doc.
×
×
  • Create New...