marcsmith Posted January 31, 2016 Share #1 Posted January 31, 2016 Installed my Dyna this morning it is the new model with no dip switches. The bike runs fine can't take it out my seats are being redone I am wondering how the heck you are supposed to see the status LEDs with it installed. I guess it is working or I think the bike wouldn't run. Thanks for any help Link to comment Share on other sites More sharing options...
crowrod Posted February 3, 2016 Share #2 Posted February 3, 2016 did it come with a usb cord? Link to comment Share on other sites More sharing options...
marcsmith Posted February 3, 2016 Author Share #3 Posted February 3, 2016 did it come with a usb cord? Yes it did Link to comment Share on other sites More sharing options...
crowrod Posted February 3, 2016 Share #4 Posted February 3, 2016 you asked in a older post about programming it,did you get it figured out? Link to comment Share on other sites More sharing options...
marcsmith Posted February 4, 2016 Author Share #5 Posted February 4, 2016 you asked in a older post about programming it,did you get it figured out? I think that it is set to default on curve two with the rev limiter set to 7500. From I have have found by searching is between 3 or 4 on the old style. I know you can plug it in to a laptop and fine tune it but it should be done on a dyna. I will run with it when I can and see how it does. My seats are currently being recovered so I can't test ride. I was just wondering how they expect you to see the little led operating lights that are on it. The directions said you could look through the frame but there is no way to see them. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now