Daitan Posted May 25, 2013 Share #1 Posted May 25, 2013 I have seen some pictures of what some have done to their 1st Gens. Replacing and modifying the side control panels. What material did you use for that? I am looking to do some cosmetic work, and minor fabrication. This would be for the top of the sides, where the radio sits and the air control for the suspension. Thanks Link to comment Share on other sites More sharing options...
dingy Posted May 25, 2013 Share #2 Posted May 25, 2013 I used a piece of lexan to rework the radio opening. Gary Link to comment Share on other sites More sharing options...
Black wing Posted May 25, 2013 Share #3 Posted May 25, 2013 (edited) i chopped out the original radio and took the amp out of the fairing, used the stock remover for the radio for easy access. and installed a marine plate its very clean when closed and does an awesome job keeping the rain off the deck. i also ran an antenna for the XM onto the trunk. used some textured black plastic to fill the voids. only material used was black textured plastic and Norton plastic epoxy Edited May 25, 2013 by Black wing Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now