Brake/running light backrest mod

9 images

• 

  Here is a view of the LED's on the backrest.

  By usnmustang
• 

  The top light is mounted through the metal plate for the backrest. I tapped the holes and used the

  By usnmustang
• 

  Drilled holes in the mount bracket and the right post. If you do this, drill on the other side. Th

  By usnmustang
• 

  LED mount gasket. I cut a track for the wires to lay flat so the LED stip was flush to the backrest

  By usnmustang
• 

  The cap pops right out. Drilled a hole through the center to feed the wires through.

  By usnmustang
• 

  Another picture of the mount mechanism and wiring. Used chafing line and heat shrink to prevent sho

  By usnmustang
• 

  Picked up a 4 pin connector from Radio Shack. This allows the removal of the backrest. The 4 wires

  By usnmustang
• 

  Close up of the connector at the base of the backrest mount. Left enough slack to allow my fingers

  By usnmustang
• 

  I ran the wiring under fender and used the stock clip run to get it to the back. Wiring is in a cha

  By usnmustang