rubber on floorboards

[dacheedah]

Any trick to getting the little rubber feet through the floorboard holes?? Had mine off and having trouble putting them back on

[mbrood]

If you are talking about the rubber nubs on the 1st gen... I used a soda straw, slice it and put one end in the hole and the other over the nub the worked them together to get the nub in...

 

There's probably an easier way, and yeah, silicon spray helps LOTS of things!!!

[Owen]

I used one loop of dental floss. Don't pull too hard.

[gscbertrand]

grease them.

[playboy]

I used one loop of dental floss. Don't pull too hard.

 

 

 

or fishing line wrapped around it a couple of times then thread both ends through the hole in floor board once the rubber is pulled through pull one end of the line real pita I won't do it again.

[bill in mn]

I cut mine off and silicone calked it in place. I have allot of faith in silicone we use it all the time at work and we just keep coming up with new things to use it on. but I do like the straw idea.

[Caveman]

I used a pair of roach cli..... um hemastats for splinter removal and pulled it through. Worked great.

[CaptainJoe]

Carb cleaner and needle nose pliers.

 

Will make rubber greasier than all get out and dries fast.

 

Also use this to put on rubber hoses that don't want to cooperate....