HD Adapter Plates

[lazyjmc]

I am looking for a set of adapter plates for HD mufflers. I have tried emailing the address on the ad on the site with no response. Does anyone know if he is still selling these brackets and if not where else I could get some?

[MidlifeVenture]

Could always make them the one with the angle cut is is easy with a cutting wheel and drill. http://www.venturerider.org/forum/showthread.php?t=34426

[wes0778]

Never seen it done, but some folks say they can be mounted using an electrical conduit "P" clamp. On my bike, the PO welded mounting tabs to the frame rails.

[gibvel]

I ordered some from him the last part of last year so he was still selling them then. Don't know why he hasn't answered.

 

Have you tried a PM to him?

 

I see it's been awhile since he's been on the forum however so I don't know what's up with him. He doesn't have any of the brackets on ebay so maybe he's stopped making them.

 

There are a couple of templates for making your own on this site. I'll post drawings if I can find some.

 

Never mind, Midlife's post has a link to the 3 drawings available.

 

[SilvrT]

Use the drawings posted above. I made mine before I knew the drawings existed. Get a length of flat aluminum 2" wide x 1/8 or 3/16.

 

Mount your muffler and line up a piece with the holes, mark and drill and cut to length.

 

(assuming of course that you have the appropriate tools and ability)