Search the Community
Showing results for tags '1.25'.
Found 2 results
-
I did a rookie thing and screwed up (I hope not big time). To make a long story short, What size tap should I use to clean the female starter threads out on the inside of the drive shaft that the Flywheel bolt screws into? And where can I get one? It looks like a M12 x 1.25 thread pitch. I've tried Sears, Harbor Frieght, Northern Tool and NAPA. None of the sets they sell have that particle size included in them. -
I recently purchased an F4 Customs windshield...and am EXTREMELY happy with it, except for one little (very minor) thing. I have searched the internet till I am tired...and I KNOW how to search...but still can't find the info I am looking for. OK...so here's the info I am needing. I looked at my STOCK WINDSHIELD to see how the tint strip was laid down and this is what I found out... The first layer is a FLAT BLACK layer of TAPE that is 1.25 inches wide. And on top of that and overlapping the black is another 1.25 inch of clear tape with black dots of graduated sizes (which screens the light)...just like you see on cars. I have tried to find this "tape" or "tapes" on the net and can't find it anywhere, in fact, I don't even know the terminology to use...so if you look at your stock shield, you'll see what I am talking about. Can anyone provide any info? Thanks. Wally
