Jump to content
IGNORED

Lower Temp Fan Switch


JoeKanuck

Recommended Posts

Like many, I noticed my water temp gets very close to the redline before the fan kicks in. Once it does, it cools down nicely but I feel more comfortable with the fan coming on at a lower temperature.

 

The thread for the switch is 16m x 1.5. Using that info, I did some searching. I found a good cheap alternative on ebay that switches on the fan significantly earlier than the stock one. The one I got was from a 1988 Chevy Sprint, part number Beck Arnley 201-1367. It is normally open.

 

Opens @ 185 Deg. F; Closes @ 194 Deg. F

 

Fits in with no problem and works like a charm. Fan comes on a lot more but the water temps don't get over half way up the temp gauge. It cost me 5 bucks plus shipping. Just cut off the connector and add a couple of flat, male connectors and they will fit right into the stock harness.

Edited by Freebird
Link to comment
Share on other sites

×
×
  • Create New...