dingy Posted November 21, 2009 Share #1 Posted November 21, 2009 (edited) I have made the following write up of the process of cleaning the throttle side switch housing that came off of a 1983 Venture. This switch is from a Venture without cruise control. The 1983 to 1985 models should be similar. The pictures show the switch completely removed from the bike. I would recommend removing switch from bike if you perform this cleaning. There are a number of small springs and ball detents that are very easy to lose unless you have a large well lit working area. If you are unable to open the PDF file, PM me with your email address and I will send it to you. I have detailed the clutch side switch in another thread. Picture below is of the switch detailed in this PDF file. 38774.pdf Edited February 14, 2016 by Freebird Link to comment Share on other sites More sharing options...
Recommended Posts