rebelbull69sbcglobal.net Posted April 30, 2008 Share #1 Posted April 30, 2008 i have seen a post on drilling mufflers but thanks to another member on this board {sorry dont remember the name} anatomy of a muffler i have found i cannot do it this certain way with my mufflers. i have the cones and if i took them off i would have the middle pipe sticking out. my question is how is the best way to do this? thanks alot Link to comment Share on other sites More sharing options...
Marcarl Posted May 11, 2008 Share #2 Posted May 11, 2008 Don't know how much noise you are looking for, but I just drilled mine out with a 7\8 spade drill bit. From both ends. Gives a bit of a rumble, not anything loud but enough to show that work is being done. Easy to do, all you need is a long extension, the metal is really quite easy to drill out. Link to comment Share on other sites More sharing options...
FROG MAN Posted May 11, 2008 Share #3 Posted May 11, 2008 I sawed mine at the weld with a hacksaw and drilled them out. Yea I know one of the holes is not uniform. But hey when I'm cruising nobody notices. The noise is not bad for the rider. I still listen to my am,fm ok. Link to comment Share on other sites More sharing options...
a1bummer Posted May 13, 2008 Share #4 Posted May 13, 2008 Check out this post to see what's inside. http://www.venturerider.org/forum/showthread.php?t=3365&highlight=anatomy Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now