Jump to content
IGNORED

Luggage rack on the SVTC


Recommended Posts

I have the 18' SVTC and purchased the luggage rack for the trunk lid and received it yesterday, since you have to drill holes to mount it I'm not seeing any type of rubber washer or grommet that would help seal the holes in the truck lid. I know it's a 2 layer set up but I'm sure if water gets in between the two it can still cause issues. I have yet to put it on but I was just wondering if anyone else has this accessory and what luck you have had with it?

Link to comment
Share on other sites

I haven't purchased the rack for my SVTC yet. But on my Goldwing (which was an inner and outer layers, I got rubber washers glued them together in stacks between the two layers to keep from compressing the outer/inner layers too much. I also would take my rack off unless I was going on long trips and needed it. I found flush mount plastic black plugs at Lowes to press into the holes when I didn't have the rack on

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...