I figure they need some rubber so they are flexible and absorb the vibration so I came up with this

   
Uploaded by: usnmustang
Album: Keeping stock bar weights on my RSTD, a new idea
Category:
0 Thanks, 0 Likes
Rating
You cannot rate images

Description

  1. I figure they need some rubber so they are flexible and absorb the vibration so I came up with this plan. I went to the hardware store and picked up a 1/4x4 bolt, flat washer and matching nut. Also picked up a nylon spacer, 1 long, 1/2 OD and .257 ID. They are in the bins at Home Depot in the bolt isle.
    I cut the spacer in half with a hack saw at a heavy angle like this.

Comments Leave Comment

You do not have permissions to add comments.