Huggy Posted July 30, 2014 Share #1 Posted July 30, 2014 OK what can I use to replace the rear fender moulding on my 86 VR? Part # 1NL-21694-00-00 & 1NL-21695-00-00. Link to comment Share on other sites More sharing options...
Prairiehammer Posted July 30, 2014 Share #2 Posted July 30, 2014 Perhaps split some small diameter vacuum hose and slip it on? Shouldn't be able to go any where after it is sandwiched between the 'flap' and the saddlebags. Link to comment Share on other sites More sharing options...
Huggy Posted July 30, 2014 Author Share #3 Posted July 30, 2014 Geeee..... Good idea I never would have thought of that. I've started to put the bike back together!! Link to comment Share on other sites More sharing options...
Prairiehammer Posted July 30, 2014 Share #4 Posted July 30, 2014 Another thought: look for some 'door edging', the plastic channel that folks slip onto the car door edge to prevent paint chipping. It may be too rigid to conform to the tight radii of the flap and the interior channel may be a loose fit on the thin flap. Link to comment Share on other sites More sharing options...
Huggy Posted July 30, 2014 Author Share #5 Posted July 30, 2014 I'll see if I have any of that stuff around and try it out. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now