bmannon Posted September 5, 2008 Share #1 Posted September 5, 2008 are these mufflers direct bolt on replacements for a first gen? http://www.macperformance.com/store/category.cfm?SID=3&Category_ID=912&Catlevel=3 wondering because it says they fit ''all models'' Link to comment Share on other sites More sharing options...
Condor Posted September 5, 2008 Share #2 Posted September 5, 2008 are these mufflers direct bolt on replacements for a first gen? http://www.macperformance.com/store/category.cfm?SID=3&Category_ID=912&Catlevel=3 wondering because it says they fit ''all models'' Pretty much a direct bolt on. You'll need to swap out the bolts to shorter ones, and mess around a bit getting them on, but they're made to replace the OEMs. Link to comment Share on other sites More sharing options...
bmannon Posted September 5, 2008 Author Share #3 Posted September 5, 2008 Pretty much a direct bolt on. You'll need to swap out the bolts to shorter ones, and mess around a bit getting them on, but they're made to replace the OEMs. OK Thanks, I was looking at the originals that are on the bike and it looks like the have a bend in them, and I wasnt sure if that was built into the muffler or if it is a seperate piece. Link to comment Share on other sites More sharing options...
Condor Posted September 5, 2008 Share #4 Posted September 5, 2008 OK Thanks, I was looking at the originals that are on the bike and it looks like the have a bend in them, and I wasnt sure if that was built into the muffler or if it is a seperate piece. All one piece.... Link to comment Share on other sites More sharing options...
bmannon Posted September 5, 2008 Author Share #5 Posted September 5, 2008 All one piece.... So just to clarify, the Macs have the bend in them also? Link to comment Share on other sites More sharing options...
Condor Posted September 5, 2008 Share #6 Posted September 5, 2008 So just to clarify, the Macs have the bend in them also? Yes...... if they didn't have a bend they wouldn't be slip-ons........ Link to comment Share on other sites More sharing options...
bmannon Posted September 5, 2008 Author Share #7 Posted September 5, 2008 Yes...... if they didn't have a bend they wouldn't be slip-ons........ Thanks a lot for the responce, I just wanted to make sure before I ordered a set because if I had to fab up a bend I was just going to get some of the super cheap turn downs that JC Whitney sells. Link to comment Share on other sites More sharing options...
Condor Posted September 5, 2008 Share #8 Posted September 5, 2008 Thanks a lot for the responce, I just wanted to make sure before I ordered a set because if I had to fab up a bend I was just going to get some of the super cheap turn downs that JC Whitney sells. No Problem. Check the link out. http://www.venturerider.org/forum/showthread.php?t=22324 Link to comment Share on other sites More sharing options...
bmannon Posted September 5, 2008 Author Share #9 Posted September 5, 2008 No Problem. Check the link out. http://www.venturerider.org/forum/showthread.php?t=22324 sent you an e-mail about those extra sets you have.... Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now