Lug Nut Posted May 3, 2016 Share #1 Posted May 3, 2016 1998 RSTC. Pulled the middle gear cover to look at clutch slave cylinder (leak)...found pieces of the bearing in the cover and cam see where chunks of the bearing are missing. I can order the shim, bearing, thrust washer, spring retail ers and middle drive gear nut for less than $100 so that's not too bad. Is this a hard job? Will I need any special tools? Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now