Additional lighting?????

[cruiserfan]

I was thinking about adding some additional some additional lighting to the rear of my bike, Since it is not a Venture, a lightbar on the trunk is out. So, any ideas? Suggestions? Thoughts? I have already installed the Kuryakyn run/turn/brake controller so I have a little more back there. My opinion is the more the merrier!!

[Crash]

How about the Harley Licence Plate Light Kit and or DiamondR rail lights? I have a Venture but would look fine on a TD.

[Stoutman]

The Harley lights would work. I may still put them on. For now I use the Signal Dynamics license frame. I also added two more LEDs on a piece of aluminum angle that attaches to the bottom of the license plate. My gallery has a picture. It is very unobtrusive, but still brigher than stock. Also, I hate relying on a single bulb for my brake light and running light. If it goes out you are dark.

Here is a link to my gallery picture.

http://www.venturerider.org/forum/vbpicgallery.php?do=big&p=236

[Tartan Terror]

I was thinking about adding some additional some additional lighting to the rear of my bike, Since it is not a Venture, a lightbar on the trunk is out. So, any ideas? Suggestions? Thoughts? I have already installed the Kuryakyn run/turn/brake controller so I have a little more back there. My opinion is the more the merrier!!
Cruiserfan, what was the Kuryakyn number for the run,stop, brake module. The dont have the Venture listed and I send them an email but they never got back to me and I want one. I think custom Dynamics makes one too.

Scotty

[Crash]

Tartan Terror, check this one out, http://www.customdynamics.com/tailconversion_kit.htm#Run-Turn-Brake_Controller_and_Diode_Kit_-Metric_Cruisers

[wuzfuzz]

Signal Dynamics Tri-Star "XP" gives you running/clearance lights, and brake lights as well as your rear signals. You must, however, acquire your own red lenses (or red bulbs with clear lenses).
The red lenses can be acquired at.....

http://www.crc2onlinecatalog.com/turn_lens.htm

The Signal Dynamics Tri-Star "XP" is available through many sources.

ken.jo@shaw.ca

[Tartan Terror]

Here is one that is Plug and Play from Hellraiser customs.

http://www.hellrisercustoms.com/selector.php?group=7&category=Lights&subcat=Turn+signals&title=Lighting%20products%20for%20Royal%20Star

[cruiserfan]

Cruiserfan, what was the Kuryakyn number for the run,stop, brake module. The dont have the Venture listed and I send them an email but they never got back to me and I want one. I think custom Dynamics makes one too.

Scotty
Part number 4710, direct from Kuryakyn. You may find that you need a second load equalizer after installing it. This is the second bike I have put this on and both needed 2 equalizers.